440.543.8660

Mon. - Fri.

8am - 5pm

sales@thermoprene.com

Project Details

Rubber Edge Guard

Rubber Edge Guard

Well-designed components make use of extrusion for its low development cost. Exampled here a small (short cut length) extrusion is punched to make the finished good. This item could be molded at a lower cost, but would not be a good candidate without very high volume. Tooling cost would be many times higher.

Material: EPDM Rubber

Size/Weight: Approximately 1.5” wide

Processes: Profile Extrusion, cut to length, holes punched

Industry/Application: Not disclosed

 

440.543.8660
sales@thermoprene.com